Engraved Photo Size
Product Description
After sending us your Photo, we will Resize to the size you select here and run the Photo through several sophisticated software programs to prepare it for Laser Engraving. We can then (upon request) send you a 'Simulation' photo to give you a better idea of the appearance of the end product.
Please select the photo size you wish to engrave on the material you have selected. Typically allow 1/2 to 1 inch per side for border (except most tiles & buttons which have no border).
Example: Shown here is a 7in x 9in Alderwood Plaque which required a 5in x 7in Engraved Photo Size selection.
Side-Note: This was actually scanned in from a 2.5in x 3.5in wallet photo, at 300 DPI and then we used our software to enhance for this Engraving - AMAZING DETAIL! We can use anything you have - old photos, new, large, small... just bring it by or e-mail mark@lazomark.com .
Please select the photo size you wish to engrave on the material you have selected. Typically allow 1/2 to 1 inch per side for border (except most tiles & buttons which have no border).
Example: Shown here is a 7in x 9in Alderwood Plaque which required a 5in x 7in Engraved Photo Size selection.
Side-Note: This was actually scanned in from a 2.5in x 3.5in wallet photo, at 300 DPI and then we used our software to enhance for this Engraving - AMAZING DETAIL! We can use anything you have - old photos, new, large, small... just bring it by or e-mail mark@lazomark.com .
